The LED task light features a flashing and steady light, two separate functions in the same package. The LED task light module has a high flash rate 10Hz which is important in attracting attention in low visibility conditions. This is a three wire unit with wires for Steady, Flashing and battery negative. Epoxy encapsulated to seal out moisture. It uses LOW power, so minimal that you can power it from a single 9 volt battery. Low drain on battery and alternator equals more horsepower, more valuable horsepower available to lower fuel consumption. No resistor to install or break like other LED lights. 12 Vdc versions also available. |
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Please note, Pilotshop.com's personnel are not certified aircraft mechanics and can only provide general support and ideas, which should not be relied upon or implemented in lieu of consulting an A&P or other qualified technician. Pilotshop.com assumes no responsibility or liability for any issue or problem which may arise from any repair, modification or other work done from this knowledge base. Any product eligibility information provided here is based on general application guides and we recommend always referring to your specific aircraft parts manual, the parts manufacturer or consulting with a qualified mechanic.
Per the manufacturer, the LED task light module 24V White are 18 Super Bright White LEDs.